Interior Maintenance HVAC, Plumbing Schematics Reduce Emergencies

Your water heater is one of the most used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating as well as costs.

Regular flushing of your water heater are probably the single most important step you consider to prolong its service life this particular save energy. A duration of time, sediments amass in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most involving the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a week.

To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on a water inlet line going into your water heater. Equipped to connect a garden hose to the drain valve located towards the end of the heater. Open the drain and allow it to play until all from the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until drinking water flows out quickly. This will allow air to vent from the heater and the water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and products to suit your needs.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Bookmark the permalink.